Roland G-800 - Page 48

G-800 Reference Manual
Reverb (0- 127)
This parameter sets the Reverb send level for the selected track. “0” means that the part in
question is not processed by the Reverb effect, while “127” represents the maximum effect
depth.
Chorus (0- 127)
This parameter sets the Chorus send level for the selected track. “0” means that the part in
question is not processed by the Chorus effect, while “127” represents the maximum effect
depth.
Tone/Drum Set
Depending on the track you selected, the message between the track name and the Tone or
Drum Set address will read Tone or frum Set. By now, you know that you can only select
Drum Sets for the 1ADR track/part. For all other tracks, the Toris message will be displayed.
Y ou can select Tones and Drum Sets using either the TONE selection keys on the front panel
or the [UPPER/VARIATION] knob.
General remark
The default settings for these parameters are as follows:
Parameter 2ABS | 3AC1
Expression
Reverb
Chorus Cone o E ee ee | eee O a
Tone/Drum Set A11 A11 | All A11 A11 A11 All A11
These values will be automatically recorded the first time you select a track for recording.
Note that you can select other Tones/Drum Sets on almost any UsrStl\Rec page (but only with
the TONE buttons). Selecting the right Tone or Drum Set before you start will help you “get
in the mood”. Leave the other settings for later, when you have a clearer idea about the sound
image.
46