Roland G-800 - Part Select buttons; G-800 modes

Before you start, Part Select buttons
Part Select buttons
These buttons are used to select the Realtime part you want to assign another Tone to.
Remember that using the [PAGE] A/F buttons may place a part on the top line without acti-
vating it for Tone selection.
G-800 modes
The G-800 interface is provided with different environments, each one related to a specific
group of functions.
The Function keys [F1]~[F5] allow you to switch between different modes.
[F1] Mixer (see page 14)
[F2] Param (see page 24)
[F3] Midi (see page 78)
TFA]
|
UserSti(see
page
40)
or
Lyrics
(see
page
8)
[F5] Disk (see page 93)
There are two other modes that can be selected using dedicated buttons: Volume and Tone.
The Volume mode(see page 8) allows you to set the volume of all G-800 parts, while Tone
(see page 10) is a useful mode when you wish to assign other Tones to a part without having
a clear-cut idea about the kind of Tone you need, or to assign other Tones to the Arranger
parts, which may be necessary for GM/GS compatibility reasons.