Roland GAIA 2 - Page 86

86
Navi
MFX List
Parameter Value Explanation
DLTime Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Dly R Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
DR.Time
1–2600 Adjusts the time until the right delay sound is heard.
DRTime Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Dly C Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
DC.Time
1–2600 Adjusts the time until the center delay sound is heard.
DCTime Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
C Feedback
-98–+98 [%]
Adjusts the proportion of the delay sound that is fed back into the eect
(Negative values invert the phase).
HF Damp
Adjusts the frequency above which sound fed back to the eect is ltered out. If you don’t want to
lter out any high frequencies, set this parameter to BYPASS.
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000, BYPASS
[Hz]
Left Lv
0–127
Volume of each delay sound
Right Lv
0–127
Center Lv
0–127
Low Gain
-15–+15 [dB] Amount of boost/cut for the low-frequency range
High Gain
-15–+15 [dB] Amount of boost/cut for the high-frequency range
Balance
D100:0W–D0:100W Volume balance between the direct sound (D) and the delay sound (W)
Level
0–127 Output Level
44 Reverse Dly (Reverse Delay)
This is a reverse delay that adds a reversed and delayed sound to the input sound. A tap delay is connected immediately after the
reverse delay.
R outR out
L outL outL inL in
Rev. Rev.
DelayDelay
DelayDelay
2-Band 2-Band
EQEQ
2-Band 2-Band
EQEQ
D1
Rev
D2D3
Feedback
R inR in
Parameter Value Explanation
Threshold
0–127 Volume at which the reverse delay will begin to be applied
RDly Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
RD.Time
1–1300
Delay time from when sound is input into the reverse delay until the delay
sound is heard
RD.Time Nt
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
RDly Fbk
-98–+98 [%]
Proportion of the delay sound that is to be returned to the input of the
reverse delay negative (-) values invert the phase)