Roland GAIA 2 - Page 88

88
Navi
MFX List
45 Tape Echo
A virtual tape echo that produces a realistic tape delay sound. This simulates the tape echo section of a Roland RE-201 Space Echo.
R outR out
L outL out
Echo Level
Echo Level
Direct Level
Direct Level
L inL in
Tape Tape
EchoEcho
R inR in
Parameter Value Explanation
Mode
S, M, L, S+M, S+L, M+L,
S+M+L
Combination of playback heads to use.
Select from three dierent heads with dierent delay times.
S: short
M: middle
L: long
Repeat Rate
0–127
Tape speed.
Increasing this value will shorten the spacing of the delayed sounds.
Intensity
0–127 Amount of delay repeats
Bass
-15–+15 [dB] Boost/cut for the lower range of the echo sound
Treble
-15–+15 [dB] Boost/cut for the upper range of the echo sound
Head S Pan
L64–63R
Independent panning for the short, middle, and long playback heads
Head M Pan
L64–63R
Head L Pan
L64–63R
Distortion
0–5
Amount of tape-dependent distortion to be added.
This simulates the slight tonal changes that can be detected by signal-
analysis equipment. Increasing this value will increase the distortion.
Wf Rate
0–127
Speed of wow/utter (complex variation in pitch caused by tape wear and
rotational irregularity)
Wf Depth
0–127 Depth of wow/utter
Echo Level
0–127 Volume of the echo sound
Direct Lv
0–127 Volume of the original sound
Level
0–127 Output Level