Roland GAIA 2 - Page 89

89
Navi
MFX List
Looper
46 DJFX Looper
Loops a short portion of the input sound. You can vary the playback direction and playback speed of the input sound to add turntable-
type eects.
R out
L out
L in
R in
Speed
Control
Delay
Delay
Delay
Delay
Speed
Control
Speed Speed
ControlControl
Speed Speed
ControlControl
DelayDelay
DelayDelay
Parameter Value Explanation
Length 230–12 (not straight) Length of the loop
Speed -1.00–+1.00
Playback direction and playback speed.
- direction: Reverse playback
+ direction: Normal playback
0: Stop playback
As the value moves away from 0, the playback speed becomes faster.
Loop Sw OFF, ON
If you turn this on while the sound is heard, the sound at that point will be
looped. Turn this o to cancel the loop.
If the eect is recalled with this ON, this parameter must be turned OFF
and then turned ON again in order to make the loop operate.
Level 0–127 Output Level
47 BPM Looper
Loops a short portion of the input sound. This can automatically turn the loop on/o in synchronization with the rhythm.
R outR out
L outL out
Loop Sw Loop Sw
ControlControl
L inL in
DelayDelay
DelayDelay
R inR in
Parameter Value Explanation
Length
230–12 (not straight) Species the length of the loop.
Rate Sync
OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate
0.05–10.00 [Hz] Cycle at which the loop automatically turns on/o
Rate Note
Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Timing
1–8
Species the timing within the cycle at which the loop automatically starts
(which step of the eight timing divisions at which the sound is heard)
Lenth
1–8
Species the length at which the loop automatically ends within the cycle
(the number of times that the 1/8-length of sound is heard)