Selecting a Tone (Patch)
16
Selecting a Tone (Patch)
The settings for each tone are stored in a block of memory called a “patch.” By selecting (switching between) patches, you can use
a variety of sounds.
The patches are further organized by group (A–D), bank (1–8) and number (1–8), letting you save a total of 4 x 8 x 8 = 256 patches.
1.
Press the NUMBER [1]–[8] buttons.
This selects the patch.
You can use the [VALUE] knob to select from all of the patches in order.
● You can select separate patches for parts A and B. For details on the part settings, refer to “3.2. Switching Between
Selecting Groups and Banks
Here’s how to switch the group and bank for the patches.
1.
Press the BANK [1 (5)]–[4 (8)] buttons.
This selects the bank. The bank (1Ð5, 2Ð6, 3Ð7, 4Ð8) and group (A–D) switches each time you press the same bank
button.
To Next Page
Loading...
