Roland KF-7 - Match the Tempo before You Begin Playing (Count In)

80
Chapter 3 Song Playback and Practice Functions
Chapter 3
Match the Tempo Before You Begin
Playing (Count In)
When you’re playing along with a song, you can listen to the tempo before you start
playing by adding a count-in.
This audible count before the song playback is called a “Count-In.”
fig.panel3-3
1. Press the [Metronome] button and watch the indicator light up.
The Metronome screen (p. 40) appears.
If you are not using the metronome, press the [Metronome] button so its indicator
goes out.
2. Touch <Count In>.
The following “Count In settings screen” appears.
fig.d-cntin.eps_60
3. Touch <Switch> to set this to “ON.”
With this setting, two measures count down before the song playback starts.
Cancelling the Count In
1. In the Metronome screen, touch <Count In>.
2. Touch <Switch> to set this to “OFF.”
This sets the KF-7 so that the count sound is not played.
You can have a count sound be
played before the song starts
playing back by holding down
the [Reset] button while you
press the [Play/Stop] button.
The status of the <Count In>
settings won’t be affected by
your use of this procedure.
For more about other settings
on the Count-In settings
screen, refer to “Settings for
the Count-In” (p. 146).