Roland KF-7 - Stop Recording; Listening to the Recorded Performance

92
Chapter 4 Recording and Saving the Performance
Chapter 4
When recording starts, the [ (Play/Stop)] and [ (Rec)] buttons’ indicators
light up.
Stop recording
6. Press the [ (Play/Stop)] button.
Recording stops.
The performance is recorded to the [1/Whole] button.
Listening to the Recorded Performance
7. Press the [ (Reset)] button, then press the [ (Play/Stop)] button.
The recorded performance is played back.
When you press the [ (Play/Stop)] button, playback stops.
NOTE
Any performance that has
b
een recorded is deleted when
the power to the KF-7 is turned
off. If you do not want a
performance deleted, then
save it to a floppy disk or to
Favorites. Refer to “Saving
Songs” (p. 101).
Track buttons assignments for recorded performances
When you record only a keyboard performance, the performance will be assigned to
the track buttons as follows.
• Normal performance (playing a single Tone from the entire keyboard)
The performance is recorded to the [1/Whole] button.
• Layer performance
The performance is recorded to the [1/Whole] button.
• Split performance
The left-hand part of the keyboard is recorded to the [3/Lower] button, and the
right-hand part of the keyboard is recorded to the [4/Upper] button.
• Layer performance and Split performance
The left-hand part of the keyboard is recorded to the [3/Lower] button, and layer
performance in the right-hand part of the keyboard is recorded to the [4/Upper]
button.
• Drum set or sound effect performance
Recorded on the [R/Rhythm] button.