2. Changes to the User’s Manual
22
2. Changes to the User’s Manual
Models : LEC-300/300A/330/540, LEJ-640
Articles in the User’s Manual * Master Guide for the LEF-12
* Replace the information on the following articles of the table of contents with the information found in this document.
LEC-300
(No corresponding page; new information added)
“(5-14) Switching the Ink Type”
LEC-300A
LEC-330
LEC-540
LEJ-640
LEF-12
(No corresponding page; new information added)
The ink types can be switched between EUV ink and EUV3 ink on this machine.
To switch the ink type, open the [PUMP UP] menu and change the ink type setting (p. 24).
INK CONTROL
PUMP UP
Restrictions on Switching Ink Type
The available ink types are shown below.
Available ink types Switching the ink type Switching the ink mode (p. 4)
EUVfgEUV3
OK
The ink type cannot be switched.
EUVfgEUVS
The ink type cannot be
switched.
EUV3fgEUVS
The ink type cannot be
switched.
However, there are the restrictions given below:
• Once ink is lled, the ink mode cannot be changed (
p. 4). Therefore, the color combination cannot be changed either.
• If the machine which supports the EUVS ink comes to support the EUV3 ink by upgrading the rmware, switching of
the ink type between the EUV ink and EUVS ink, which was available before the upgrade, becomes unavailable. Replace
“Restrictions on Switching Ink Type” in User’s Manual, which was supplied with the machine, with those given in this page.
Switching the Ink Type
To Next Page
Loading...
