Roland LEC-300A - Page 19

Correcting for Misalignment in Bidirectional Printing
17
2. Changes to the User’s Manual2. Changes to the User’s Manual
LEC-300/300A/330/540
6. When printing ends, press to display the gure on the below.
DETAIL SETTING
SETTING NO.1
7. Press .
Go to ”2. Enter the adjustment value.”
LEJ-640
6. When printing ends, press and then .
7. Remove the front cover 2.
8. Press and feed the media forward to a position where you can clearly see the condition of the test
print.
This operation is not necessary when using roll media or sheet media. Proceed to step 9.
9. Repeat steps 1 to 4 until the screen shown on the left appears.
DETAIL SETING
TEST PRINT
10. Press to display the gure on the below.
DETAIL SETTING
SETTING NO.1
11. Press .
2. Enter the adjustment value.
1.
Press to select one from H1 to H6 (from H1 to H3 for the LEC-300/300A)
H4 H5 H6
00 0
H1 H2 H3
000