Roland MC-101 - Using a New SD Card

Making Various Settings
17
3.
To execute, press the [VALUE] dial.
If you decide to cancel, press the [EXIT] button.
* Factory reset does not restore the contents of the SD card to
their factory-set state. For more about the data that was on the
SD card when shipped from the factory, refer to the following
URL.
& https://www.roland.com/support/
* If you want to back up the contents of the SD card included with
the MC-101 to your computer, use your computer to save the
contents on other media.
Using a New SD Card
If you’re using a new SD card, you must rst format it on
the MC-101.
1 2
3
4 5 6
1.
Remove the screws of the SD card protector (rear
panel).
The SD card protector is fastened with screws. To
remove the card protector, use a Philips screwdriver
to remove the screws.