Roland MDX-40A - Page 11

11
Model data file
+Z0SENSOR_HOLDER.igs
+/IGS format0
This guide
++MDX-40A
++Step up guide+Step,
++One side cutting version
Double sided tape
Scraper (Long stainless steel kitchen spatulas are
particularly good for this)
2-1 What to have ready
Step 2+Before you start cutting
Spanner - 2 sizes
Hexagonal Wrench – 2 sizes
Roland Software Package/CD-ROM)
SRP Player/CD-ROM)
Collet /!Q0+
USB Cable
Workpiece for modelling (Sanmodur) 1 piece
,.R+S+,RR+S+2RTT
Workpiece for base 1 piece
(wider than the workpiece for modelling)
.3U+V+.3U+V+2RTT
"Qmm Straight endmill
+/For surface levelling/Roughing/Finishing)
WXY -3RZ+Accessories
Tool
Material size
[>$*&#G I
MDX-40A Starter kit
PGll the necessary equipment is included in the starter kit, comprising of modelling material, tool, parallel
pins, guide and cutting data.