9
Step1. Setting up
The workflow of this guide
Surface
levelling the
base
Surface level
the modelling
material
Rough cutting
and Finishing
Completion
This tutorial uses the same 6mm straight end mill to
complete the surfacing, roughing and finishing.
Remove the completed model from the base.
Like the process of surface levelling the base, this cuts
the model surface so that the thickness of the workpiece
is even and appropriate for the size of model.
Use a 6 mm diameter straight endmill.
This will give a level base for the material, ensuring cutting
depths across the model are even.
To Next Page
Loading...
