14
Fix the base material to the table. Ensure it is
stuck firmly.
Prepare the base workpiece to attach to the table.
This is a sacrificial base.
Ensure the base workpiece is bigger than the
model workpiece. Clean the MDX40A table to
remove any dust or swarf.
Base
Table
Preparation of the base
Apply just enough double sided tape
to the base Too much and you wont
get it off. Ensure the tape is flat, free
of swarf and does not wrinkle or
overlap other pieces.
1
2
3
.3UTT
.3UTT
2RTT
Step 3.+Setup Tasks. Cutting the Base and workpiece
To Next Page
Loading...
