Roland Modela MDX-40 - User Manual

Thank you very much for purchasing this product.
➢ To ensure correct and safe usage with a full understanding of this product's performance, please be
sure to read through this manual completely and store it in a safe location.
➢ Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.
➢ The contents of this operation manual and the specifications of this product are subject to change
without notice.
➢ The operation manual and the product have been prepared and tested as much as possible. If you
find any misprint or error, please inform us.
➢ Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may
occur through use of this product, regardless of any failure to perform on the part of this product.
➢ Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may
occur with respect to any article made using this product.
User's Manual

Roland Modela MDX-40 Specifications

General

Model	MDX-40
Category	3D Printers
Interface	USB
Spindle Motor	DC Motor
Repeatability	±0.01 mm
Control Command Set	RML-1
Software	Modela Player 4
Operating System	Windows
Supported Materials	plastics such as ABS and polycarbonate
Power Supply	AC 100-240V

Summary

To Ensure Safe Use

Understanding Warning and Caution Notices

Interpreting Safety Symbols

Operational Safety Hazards

Covers risks from incorrect operation, machine weight, and general handling.

Electrical and Fire Hazards

Details dangers related to electricity, short circuits, electrocution, and fire.

Cutting Safety Guidelines

Rules and precautions to follow during cutting operations to prevent injury or fire.

Chapter 1 Introduction

Chapter 2 Preparation

Installation Environment and Space

Driver Installation and Computer Connection

Chapter 3 Operation

Powering the System On and Off

Emergency Stop and Safety Features

How to use the emergency stop switch and front cover safety interlock.

Tool Installation and Origin Setting

Steps for installing cutting tools and defining workpiece origin points.

Starting and Pausing Cutting

How to initiate and temporarily halt the cutting process.

Stopping and Resuming Cutting Operations

Chapter 4 Feature Reference

Setting Z-Axis Origin Using Sensor

Engraving Cutter Installation and Origin Setting

Chapter 5 Appendix

Maintenance and Inspection Procedures

Troubleshooting Common Issues

Solutions for common problems like machine not running or cutting errors.