Chapter 3 Operation
30
3-2 Emergency Stop to Ensure Safety
Emergency stop switch
This switch stops the machine in an emergency in order to avoid danger. Pressing the emergency stop switch immedi-
ately halts operation and aborts cutting.
How to Perform an Emergency Stop
Press the switch.
Releasing the Emergency Stop Switch
Turning the switch in the direction of the arrow releases the emer-
gency stop switch.
Front Cover
For safety, opening the front cover during operation stops cutting and makes the MODELING and VIEW lights flash.
To recover from this, close the front cover and switch off the sub power button.
It is possible to open the front cover while the machine is paused. When the front cover is open, the VIEW light flashes
every two seconds. Closing the cover stops the flashing.
☞ P.34"Stopping and Pausing Cutting"
To Next Page
Loading...