Roland MDX-40A - User Manual

User's Manual
Thank you very much for purchasing this product.

To ensure correct and safe usage with a full understanding of this product's performance, please
be sure to read through this manual completely and store it in a safe location.

Unauthorized copying or transferral, in whole or in part, of this manual is prohibited.

The contents of this operation manual and the specifications of this product are subject to
change without notice.

The operation manual and the product have been prepared and tested as much as possible. If
you nd any misprint or error, please inform us.

Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which
may occur through use of this product, regardless of any failure to perform on the part of this
product.

Roland DG Corp. assumes no responsibility for any direct or indirect loss or damage which may
occur with respect to any article made using this product.

Roland MDX-40A Specifications

General

Brand	Roland
Model	MDX-40A
Category	3D Printers
Language	English

Summary

Chapter 1 Getting Started

Machine Highlights

Overview of the unit, VPanel, software, and four-axis support.

Part Names and Functions

Identifies and describes front and side components, VPanel, and built-in panel.

Chapter 2 Installation and Setup

Machine Installation

Covers installation environment, space, and height requirements.

Cable Connections

Details on connecting the power cord and the computer via USB.

Software Installation and Setup

System requirements and procedures for installing drivers and software.

Chapter 3 Basic Operation

Emergency Stop Procedures

Explains how to perform, cancel, and the effect of front cover opening.

Machine Startup and Shutdown

Step-by-step guide for starting and shutting down the machine.

Selecting Machine Command Set

How to select between RML-1, NC Code, or automatic selection.

Manual Tool Movement

Using VPanel for manual feed, displaying tool position, and moving to specific locations.

Spindle Rotation Control

Instructions for starting, stopping, and setting spindle speed.

Cutting Operation Control

Procedures for pausing, resuming, and quitting cutting operations.

Chapter 4 Getting Ready for and Performing Cutting

Cutting Area and Workpiece Setup

Defines the usable cutting area and workpiece placement.

Tool Installation

Covers tool selection, features, and the procedure for installing end mills.

Starting the Cutting Process

Steps for setting origin points and outputting cutting data.

Adjusting Cutting Overrides

How to adjust feed rate and spindle speed during operation.

Chapter 5 Appendix

Using the Z-Axis Sensor

Explains the sensor's function and setting the Z origin.

Engraving Cutter Installation

Procedures for installing the engraving cutter and setting origin points.

Machine Maintenance

Cleaning procedures and spindle unit maintenance.

Troubleshooting Common Issues

Addresses power issues, initialization failures, and VPanel errors.

Error Message Handling

Guidance on interpreting and responding to various machine error messages.

Power and Serial Number Information

Location and importance of serial number labels and power rating information.

NC Code Settings and Interpretation

Details on NC code settings, interpretation, and supported commands.

Technical Specifications

Provides details on expansion connectors, external views, dimensions, and main specs.