Chapter 3
Basic Operation
This describes the basic operation methods. If you're using the ma-
chine for the rst time, then before you start operations, be sure to
read this.
3-1 Types of Emergency Stops to Ensure Safety .............42
How to Perform an Emergency Stop. ............................ 42
To Cancel an Emergency Stop ...................................... 42
Emergency Stop Due to Opening or Closing the Front
Cover ............................................................................. 42
3-2 Starting and Quitting ...................................................43
How to Start the Machine .............................................. 43
Shutdown ....................................................................... 45
3-3 Selecting the Command Set .......................................46
What is Command Set? ................................................. 46
Selecting Command Set ................................................ 46
3-4 Moving the Tool ...........................................................48
Manual Feed .................................................................. 48
About the Displayed Tool Position ................................. 49
Moving to a Specic Position ......................................... 51
Moving to the VIEW Position ......................................... 51
3-5 Starting and Stopping Spindle Rotation ......................52
Starting or Stopping the Spindle .................................... 52
3-6 Pausing/Resuming/Quitting of Cutting ........................53
Pausing and Resuming of Cutting by Operation of the
Machine ......................................................................... 53
Quitting Cutting by Operation of the Machine................ 54
Quitting Cutting by Operating from the VPanel ............. 55
41
To Next Page
Loading...
Need help?
General
