Roland MDX-40A - Removing and Storing the Retainers

Chapter 2 Installation and Setup
2-2 Installation
33
Chapter 2 Installation and Setup
Removing and Storing the Retainers
Retaining materials are attached to protect the machine from vibration during shipment. When instal-
lation is complete, remove these and store in the specied locations.
 Remove all Retaining materials. Any that remain may cause faulty operation or breakdown when
the power is switched on.
 The Retaining materials are required when moving the machine to a dierent location. Store them
carefully so that they do not get misplaced.
WARNING
Carry out these operations before you connect the power cord.
Inadvertent powerup may result in pinched hands or other injury.
Procedure

Make sure the power cord is not connected.

Remove the screws shown in the gure, then detach these retainers.
Retainer
Retainer
Hexagonal wrench
Hexagonal
wrench