Chapter 4 Getting Ready for and Performing Cutting Chapter 4 Getting Ready for and Performing Cutting
4-3 Starting Cutting
67
Chapter 4 Getting Ready for and Performing Cutting
Recovery of Operation from Emergency Stop or Emergency Shutdown
If an emergency stop or an emergency shutdown occurs during cutting, remove the tool and the
workpiece from the machine. When the operation resumes, initialization is performed on the machine.
At this time, the tool and the workpiece may collide depending on the position in which the tool and
workpiece stopped, which can cause damage to the machine while restarting.
P. 43, "Starting and Quitting"
To Next Page
Loading...
