Chapter 2 Installation and Setup
31
Chapter 2 Installation and Setup
2-2 Installation
Installation Environment
WARNING
Unloading and emplacement are operations that must be performed
by 4 persons or more.
Tasks that require undue effort when performed by a small number of
persons may result in physical injury. Also, if dropped, such items may
cause injury.
The weight of the machine alone is 65 kg (144 lb.). Perform unloading and emplacement with care.
Installation Environment
Install in a quiet, stable location oering good operating conditions. An unsuitable location can cause
accident, re, faulty operation, or breakdown.
WARNING
Install in a location that is level and stable.
Installation in an unsuitable location may cause an accident, including
a fall or tipover.
WARNING
Never install in a location exposed to open ame.
Cutting waste may ignite. Powdered material is extremely ammable,
and even metal material may catch re.
WARNING
Never install close to any ammable object or in a gas-lled loca-
tion.
Combustion or explosion may be a danger.
WARNING
Never install out of doors or in any location where exposure to water
or high humidity may occur.
Doing so may result in re or electrical shock.
WARNING
Position so that the power plug is within immediate reach at all
times.
This is to enable quick disconnection of the power plug in the event
of an emergency. Install the machine next to an electrical outlet. Also,
provide enough empty space to allow immediate access to the electri-
cal outlet.
○ Never install in a location subject to wide uctuations in temperature or humidity.
○ Never install in a location subject to shaking or vibration.
○ Never install in a location where the oor is tilted, not level, or unstable.
○ Never install in a dusty or dirty location, or out of doors.
○ Never install in a location exposed to direct sunlight or near air-conditioning or heating equip-
ment.
○ Never install in a location exposed to considerable electrical or magnetic noise, or other forms of
electromagnetic energy.
○ Never install in an environment where silicone substances (oil, grease, spray, etc.) are present.
To Next Page
Loading...
Need help?
General
