Chapter 5 Appendix Chapter 5 AppendixChapter 5 Appendix
5-3 Maintenance
77
Chapter 5 Appendix
Maintenance of the Spindle Unit
The spindle unit and the belt are parts that wear out. The replacement cycle varies according to usage
conditions, but as a general guide, you should replace them after every 2,000 hours of use. You can
use VPanel to view the total working time of the spindle. Refer to this to determine when replacement
is needed. For information on how to perform replacement, refer to the documentation included with
the ZS-40 replacement spindle.
As a general guide, replace the spindle motor after every 6,000 hours of use.
Checking the total working time of the spindle using VPanel
The total working time
of the spindle is reset.
Click [Setup].
Total working time of the spindle
To Next Page
Loading...
Need help?
General
