Chapter 3 Basic Operation
3-6 Pausing/Resuming/Quitting of Cutting
55
Chapter 3 Basic Operation
Quitting Cutting by Operating from the VPanel
This stops cutting through operation using VPanel.
Procedure
Click [Quit Cutting] during cut-
ting.
The tool movement is stopped on the
spot, and the VIEW lamp comes on.
Rotation of the spindle does not stop
at this time.
Conrm the message and click
[Quit Cutting].
The spindle rotation stops, and the VIEW
lamp goes dark. This completes the quit-
ting of cutting operation.
Dark
Lighted
To Next Page
Loading...
