Chapter 4
Getting Ready for
and Performing Cut-
ting
This section explains the preparations for cutting such as installing the
tool and setting the reference position of the cutting, and the method
for outputting the cutting data
4-1 Cutting Area ................................................................58
Workpiece Size and Location Where Secured in Place 58
Actual Size That Can Be Cut ......................................... 58
4-2 Installing a Tool ...........................................................59
Tool Selection ................................................................ 59
Features of the Tools ..................................................... 59
Installing a Tool (End mill) .............................................. 59
4-3 Starting Cutting ...........................................................61
About Origin Point ......................................................... 61
Setting Origin Point ........................................................ 61
Start Cutting (Output to the machine directly form the ap-
plication) ........................................................................ 64
Start Cutting (Output via VPanel) .................................. 65
Recovery of Operation from Emergency Stop or Emergency
Shutdown ....................................................................... 67
4-4 Override ......................................................................68
What's an Override? ...................................................... 68
How to Make the Settings for Overrides ........................ 68
57
To Next Page
Loading...
