Chapter 2 Installation and Setup
2-4 Installing and Setting Up the Software
37
Chapter 2 Installation and Setup
The Software You Can Install and Set Up
VPanel for MDX-
40A
This is a dedicated software for controlling this machine. You operate
this machine and make various settings using this software.
Windows driver This is a Windows-based driver required for sending data from a com-
puter to the machine.
SRP Player This is a CAM software that imports general-use 3D data, such as IGES,
DXF (3D), or STL, and outputs tool paths to the machine.
Note: For information on installation and setup, refer to the separate
SRP Player Installation and Setup Guide.
Dr. Engrave This is a software for engraving text and shapes. It can use any Tru-
eType fonts registered with Windows. It also comes with its own stroke
fonts.
3D Engrave This software is for designing and engraving reliefs (raised engravings),
supporting at engraving. This lets you easily add thickness to text,
shapes, and imported images, and create three-dimensional reliefs.
Virtual MODELA
(for 3D Engrave)
This software is for performing simulations before you actually carry
out cutting using 3D Engrave. It lets you verify the nished results for
shapes, the time required for cutting, and other factors.
ClickMILL This software is useful for post-cutting the material, for example, cutting
the inner side of shapes (“pocket-cutting”), cutting out the material to
the specied shape (“cutout”), or cutting the surface of the material to
a uniform depth (“surface leveling”).
Information on how to use the included software is found in electronic-format manual for
each software.
P. 40, “Viewing the Documentation for the Softwares”
To Next Page
Loading...
Need help?
General
