46
Chapter 3 Basic Operation
Chapter 3 Basic Operation
3-3 Selecting the Command Set
What is Command Set?
In this machine, the following command sets are available for selection.
RML-1
Select when you want to use the software that is included with the machine.
NC code
Select when you want to use the NC code. For the details of NC code, refer to "NC Code Specica-
tion" on page 87 and "NC Code Reference Guide" that is included with the machine.
Selected automatically (RML-1/NC Code)
The machine becomes ready to accept the cutting programs of RML-1 and NC code command
sets.
Select the appropriate command mode to match the application software to be used. If a command
that is sent to the machine is dierent from the command set selected on the VPanel, an error occurs
and cutting becomes impossible.
Command set is displayed on the title bar of the VPanel. The setting at shipping from the factory is
“RML-1.”
Selecting Command Set
Procedure
Start the machine.
P. 43, "How to Start the Machine"
Click the [Setup] button on the
VPanel.
The "Setup" screen appears.
Command set that is currently selected
To Next Page
Loading...
Need help?
General
