24
Chapter 1 Getting Started
Chapter 1 Getting Started
Chapter 1 Getting Started
1-1 Machine Highlights
Overview of the Unit
RML-1/NC code support
This machine supports both RML-1 and NC code; therefore it is applicable for a wide-range of software.
RML-1 is a control command exclusive to Roland D.G. modeling machine. When outputting from the
included application to the machine.
Easy-operation VPanel
This machine is operated from the computer screen by using the included application software, “VPanel.”
The VPanel moves the tool, turns on/o the spindle rotation, sets the origin, and outputs the cutting
data.
A full array of software included
In order to enable modeling immediately after the cutting data is created, the exclusive CAM softwares
are included. Cutting software is also included to meet various usages.
P. 37 “The Software You Can Install and Set Up”
Four-axes machining operation support
Installing the optional rotary axis unit (A-axis) makes it possible to perform four-axes machining opera-
tions such as multiple-surface cutting.
Operating the Machine
This machine is operated from the computer screen by using the included exclusive application software,
“VPanel.” You can nd it on the included Roland Software Package CD-ROM.
P. 27, "VPanel," p. 39, "Installing VPanel and Other Softwares"
To Next Page
Loading...
