76
Chapter 5 Appendix Chapter 5 AppendixChapter 5 Appendix Chapter 5 Appendix
5-3 Maintenance
Cleaning
WARNING
Never use a pneumatic blower.
This machine is not compatible with a pneumatic blower. Cutting waste
may get inside the machine and cause re or electrical shock.
WARNING
Never use a solvent such as gasoline, alcohol, or thinner to perform
cleaning.
Doing so may cause re.
WARNING
Disconnect the power cord before performing cleaning or mainte-
nance.
Attempting such operations while the machine is connected to a power
source may result in injury or electrical shock.
WARNING
When using a vacuum cleaner to take up cutting waste, exercise
caution to prevent re or dust explosion.
Taking up ne cuttings using an ordinary vacuum cleaner may cause
danger of re or explosion. Check with the manufacturer of the vacuum
cleaner. When the safety of use cannot be determined, clean using a
brush or the like, without using the vacuum cleaner.
CAUTION
Caution: high temperatures.
The cutting tool and spindle motor become hot. Exercise caution to
avoid re or burns.
CAUTION
When performing maintenance, be sure to keep the cutter de-
tached.
Contact with the blade may cause injury.
This machine is a precision device. Carry out daily care and maintenance.
Carefully clean away cutting waste. Operating the machine with a large amount of cutting waste
present may cause malfunction.
Never apply silicone substances (oil, grease, spray, etc.) to the machine. Doing so may cause poor
switch contact.
Never apply lubrication.