Chapter 3 Operation
34
3-5 Stopping and Pausing Cutting
Pausing Cutting
Press the VIEW button.
Pressing the VIEW button moves the spindle to the left edge and the table to the
front of the machine.
It is possible to open the front cover while the machine is paused. Before you open the front cover, make sure that
operation has stopped completely.
To resume cutting, make sure the front cover is closed, then press the VIEW button again.
Stopping Cutting
➊
Press the VIEW button.
➋
Press the TOOL-UP/TOOL-DOWN buttons at the same time.
The VIEW light flashes, and deletion of the data sent to the machine begins.
When deletion of the data ends, the VIEW light stops flashing.
To Next Page
Loading...