Roland Modela MDX-40 - Setting Z-Axis Origin Using Sensor

Chapter 4 Feature Reference
36
4-1 Setting the Z Origin Using the Sensor
Setting the Z origin on the Workpiece
1. Mount the sensor.
➊
Place the sensor on the workpiece.
➋
Run the sensor cable around behind the ma-
chine to the top of the table.
Connect the sensor cable to the sensor con-
nector.
2. Set the Z origin point.
➊
Close the front cover.
Press the VIEW button to make the VIEW light go out.
➋
Using the operation panel screen, move the tool to a loca-
tion above the sensor.
➌
Select "Set the Z-axis origin using the
sensor."
Click "Start Detection."
Sensor cable
Sensor
Workpiece