Manual
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
B0059001 / Rev. 2.3
Safety advice
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
7
Declaration of conformity according to EC directives
Manufacturer: Roland Electronic GmbH
Otto-Maurer-Str. 17
75210 Keltern / Germany
Product name:
Product type:
Weld Seam Detection System
R4000
Roland Electronic GmbH declares that the product listed above complies with the requirements of
the directives listed below.
Applied Directives:
2014/35/EU Low Voltage Directive
EN 61010-1:2010
2014/30/EU: EMC Directive
EN 61000-6-2:2005/AC:2005 EN 61000-6-4:2007/A1-2011
Date of mark’s apposition: 10.05.2016
Keltern, 10.05.2016
Managing Director
Place, Date Signature Function of the signer
The declaration confirms the compliance with the cited directives. However, it is not any implied warranty of fitness for a
particular purpose especially as it may relate to product liability.
The safety instructions and warnings must be observed.
ISO 9001 : 2008
Reg.-no. 5152 QM08
Pos: 6 /Komponenten allgemein/Leerseite @ 0\mod_116 5223317234 _501.docx @ 2 343 @ @ 1
To Next Page
Loading...
Need help?
General
