Roland RD-600 - Internal Part MIDI Receive Settings; Setting MIDI Receive Channel

EEE
I
EP
PTA
SO
ST
ESSE
SE
ET
A
2
AAR
SA
RO
Parameter
Setting group
name
EReceive Ch. *
TitPart 2 iCh
Name of local part
that was assigned
IU: INT UPPER
IL: INT LOWER
WL: INT UPPER/LOWER
Selected internal part
3.Select the internal part that you wish to modify.
Use the PAGE [ <][» ] buttons to move the cursor (the blinking underline), and use the
[INC/YES] [DEC/NO] buttons to select an internal part. The selected internal part will appear
in the display.
kK
Rene
i
ier
c
kh
%
i”
TtePart Be 1Ch
4. Modify the value of the setting.
Use the PAGE [ < ][ > ] buttons to move the cursor, and press the [INC/ YES] [DEC/NO] but-
tons to modify the value of the setting.
FReceiwe Ch. ”*
ItePart 2 IC
* By holding the [INC/YES] ([DEC/NO}) button while you press the [DEC/NO] ([INC/YES]) button
you can increase (decrease) the value rapidly.
5.Repeat steps 2-4 as necessary.
6.When you are finished, press the [EDIT] button to make the indicator go dark. You will return
to normal playing mode.
Internal part parameters
Internal part settings include the following parameters.
Receive Ch.
Rx PGM
Rx Modulation
Rx Volume
Rx Hold-1
Rx Bender
Setting the MIDI receive channel (Receive Ch.)
In
order
to
play
the
RD-600
from
an
external
MIDI
device,
the
MIDI
channels
of
the
two
devices
must be set to match.
When
the
MIDI
transmit
channel
of
the
transmitting
device
(external
MIDI
device)
is
set
to
the
same
setting
as
the
MIDI
receive
channel
of
the
receiving
device
(the
RD-600),
notes
played
by
the transmitting device will be sounded by the receiving device.
If
you
simultaneously
press
both
the
[INC/
YES]
[DEC/NO]
buttons,
the
setting
will
be
turned
OFF, so that MIDI messages from the external MIDI device will be ignored.
* For details on setting the MIDI channels of the transmitting device, refer to the owner's manual of the
connected external MIDI device.
RReceive Ch, *
Range of values: OFF, 1-16
IWePart 2 ith
45