Roland RD-600 - Lever Settings and MIDI Input; Modulation and Bend Lever Settings; Using External MIDI for Internal Parts

en RE 9 a PPR CIEE ETT TE NE ET TE TT BE ET OE EE BEDI LLORES CELE EEE,
Modulation lever setting (Mod Lever Sw).................Default value: ON
For each of the local parts, this setting specifies whether or not operations of the modulation
lever will control the internal sound source or external MIDI devices. Press the [INC / YES] but-
ton to turn this ON, or press the [DEC/NO] button to turn it OFF. With a setting of OFF, the
modulation lever will not control the part.
Lifted Lever Si +
Range of values: ON/OFF
THT Le OH
Bender setting (Bend Lever Sw).............ssccccseseseeeeeeeDEfault value: ON
For each of the local parts, this setting specifies whether or not operations of the bend lever will
control the internal sound source or external MIDI devices. Press the [INC/ YES] button to turn
this ON, or press the [DEC/NO] button to turn it OFF. With a setting of OFF, the bend lever
will not control the part.
Lbend Lewer Su +
IHT L® OH
Range of values: ON/OFF
Using an external MIDI device to play the RD-600's internal
sound source (Internal Part settings)
If you connect an external MIDI device to the RD-600, MIDI messages from the external MIDI
device can be received to play the Tones that are assigned to internal parts.
Sequencer RD-600
Procedure
EDIT
€bDrr
=
vam
LOG
Conse)
LL )
NG
Zoow
1. Press the [EDIT] button to make the indicator light, and you will enter Edit mode.
2. Use the PAGE [ ~ ][ = ] buttons to select the parameter that you wish to modify.
Select a parameter prefixed by a “R” character. The setting value is displayed below the para-
meter name.
* By holding down the PAGE [ = ] ({ < ]) button and pressing the PAGE | «] ({ > }) button you can
move rapidly in the direction of [ = ] (1 « ]).
44