Roland RD-600 - Page 53

LL TET ER ELD LETT LEER TET RON ICT EP I TT TE ATE PS PE I PE TT EI IE I I IIIT E LE IETS IT IT TTT ER AS
2. For the Write operation, simultaneously press the GROUP [A] and [B] buttons in Edit mode.
The following display will appear.
Uirite SETUP
to Sil
3.Use the Category / Variation buttons to select a setup number as the writing destination
(S11-S88).
UWrite SETUP
to S24
4.When you have selected the writing destination, press the [INC/ YES] button.
A message will ask you to confirm the operation.
Write SETUP
to Se4 Sure?
5.If you wish to write the data, press the [INC/ YES] button. To cancel without writing, press the
[DEC/NO] button.
6. When the data has been written into memory, the display will indicate Complete!, and you will
return to normal playing condition.
Now the settings that were saved in this setup memory can be recalled at any time.
Write SETUP
Come Leta !
A setup memory contains the following data.
¢ Split on/off
¢ EFX UPPER on/off
¢ Equalizer on/off
* Chorus on/off
«Local part settings
INT parts
Part Assign
Key Range
Transpose
Velocity Sens
Velocity Max
DamperPedalSw
FC1 Pedal Sw
FC2 Pedal Sw
Mod Lever Sw
Bend Lever Sw
¢ Transpose on/off (and setting value if on)
° EFX LOWER on/oft
¢ Reverb on/off
TX parts
Transmit Ch.
Key Range
Transpose
Velocity Sens
Velocity Max
DamperPedalSw
FC1 Pedal Sw
FC2 Pedal Sw
Mod Lever Sw
Bend Lever Sw
Volume of each part
¢ Internal part settings (Part 1—Part 16)
Receive Ch.
Rx PGM
Rx Modulation
Rx Volume
Rx Hold-1
53