Roland RD-600 - Saving and Transmitting Data; Saving Internal Settings via Bulk Dump

ERS ra PSTD I ETI TT PA PA SIT TI I IT a TS ETS YRS NET TT ET
Rx Bender
Volume of each part
Program number for each part
* Tone settings
Tone settings that are assigned Tone settings that are assigned
to the 16 internal parts to the TX parts
Pan Pan
Coarse Tune Coarse Tune
Fine Tune Fine Tune
Reverb Amount Reverb Amount
Chorus Amount Chorus Amount
Bend Range Up Bend Range
BendRangeDown Program number
EFX Bank Select
EFX Level Attack
RATE/SENS and DEPTH/LEVEL knob condition Decay
Attack Release
Decay Bright
Release
Bright
* Tone settings which are not assigned to any internal part are not saved as part of the setup memory.
¢ Reverb/Chorus settings
Reverb setting Chorus setting
Reverb Type Chorus Level
Reverb Level Chorus Rate
Reverb Time Chorus Depth
Reverb HF Damp Chorus PreDelay
Delay Feedback ChorusFeedback
Chorus Output
* Overall system settings
Key Touch
Saving internal settings on an external sequencer
(Bulk Dump Current / Bulk Dump All)
Internal settings of the RD-600 (exclusive data) can be transmitted (bulk dump) to an external
sequencer for recording and storage.
Bulk Dump All will transmit all RD-600 data other than the Device ID, LCD Contrast, and
Powerup Mode.
Bulk Dump Current will transmit the same contents as the data that is saved in a setup memo-
ry. This allows a sequencer to be used as an external setup memory.
* In order for exclusive data to be transferred between the RD-600 and an external MIDI device, the
device ID numbers of the two devices must match (p.51).
1.Connect the RD-600’s MIDI OUT to the sequencer’s MIDI IN, and connect the RD-600’s MIDI
IN to the sequencer’s MIDI OUT.
2. Press the [EDIT] button. The indicator will light, and you will enter Edit mode.
3.Use the PAGE [ «][»> ] buttons to move through the pages, and select either Bulk Dump
Current or Bulk Dump All.
The following display will appear.
WEulk Curme HWEulk Bure
All
Bulk Dump Current display Bulk Dump All display
Currerrt.
54