Roland RD-600 - Receiving Data and Restoring Settings; Receiving Exclusive Data from Sequencer; Restoring Factory Settings (Initialize)

SA
TE
a
IE
SE
SI
TESTED
SOS
SESS
GRASS
SEY
TO
OH
9
TOI
4. Press the [INC/ YES] button.
The display will ask you to confirm the operation.
Welk
Cure
Sure?
5.Start recording on your sequencer.
6.Press the [INC/YES] button once again, and exclusive data will be transmitted from the RD-
600. To cancel the operation press the [DEC/NO] button.
7.When transmission is finished, the display will indicate Complete!
Stop recording on your sequencer.
UBulk
Curme
Lee
Complete!
The
RD-600
settings
have
now
been
recorded
onto
the
sequencer.
When
the
sequencer
is
played
back,
the
RD-600
that
receives
the
data
will
switch
to
the
corresponding
settings.
Receiving exclusive data from a sequencer
When
you
wish
to
receive
exclusive
data
that
was
recorded
on
a
sequencer,
you
must
put
the
RD-600
in
normal
playing
condition.
Such
data
cannot
be
received
when
the
RD-600
is
in
Edit
mode.
For
the
procedure
of
transmitting
the
exclusive
data,
refer
to
the
owner’s
manual
for
the
sequencer
that
you
are
using.
Restoring the factory settings (Initialize Current / Initialize All)
Initialize All will restore (initialize) all parameters of the RD-600 to their factory settings. The
contents of all setup memories will also be initialized.
Initialize Current will initialize the settings of the local parts, internal parts, and Tones. All 128
of the internal Tones will be initialized. However since the contents of the setup memories will
not be initialized, Tone settings that are saved in the setup memories will not be initialized.
1.Press the [EDIT] button. The indicator will light, and you will enter Edit mode.
2.Use
the
PAGE
[
<
][
>
]
buttons
to
move
through
the
pages,
and
select
either
Initialize
Current
or
Initialize
All.
The following display will appear.
Winitialize Winitialize oD
Current All
Initialize Current display Initialize All display
3. Press the [INC/ YES] button.
A
message
will
appear
in
the
display,
asking
you
to
confirm
the
operation.
Winitislize
Sure?
4.Press
the
[INC/YES]
button
once
again,
and
the
data
will
be
initialized.
To
cancel
the
opera-
tion,
press
the
[DEC
/
NO]
button.
5.When
initialization
has
been
completed,
the
display
will
indicate
Complete!,
and
you
will
return
to
normal
playing
condition.
55