147
REAC applications and settings
REAC applications and settings
Saving/Loading the S-4000M’s Input/Output Setups
You can save/load the S-4000M input and output setups to a USB
memory as an S-4000M Input/Output Setup file.
To save/load the S-4000M Input/Output Setup File, use the S-
4000M LOAD/SAVE popup.
1.
Access the S-4000M CONFIGURATION popup.
fig.S4M_Config1.eps
2.
Press [F4 (LOAD/SAVE)].
fig.S4M_LoadSave_Guide.eps
The S-4000M LOAD/SAVE popup will appear.
File list
This lists the S-4000M Input/Output Setup files that have
been saved to USB memory. You can specify the save-
destination folder for the file, or specify the file that you want
to load.
The function buttons have the following operations:
1.
Access the S-4000M LOAD/SAVE popup.
2.
Press [F2 (SAVE)].
fig.S4M_Save.eps
The S-4000M SAVE popup will appear.
3.
Edit the name of the S-4000M Input/Output Setup file in
the name edit field.
4.
When you press [F8 (SAVE)], a message indicating the
status of the save procedure will appear. When saving is
completed, the message will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the M-300’s
power while data is being saved to USB memory. Doing so
may destroy the data saved in USB memory.
1.
Access the S-4000M LOAD/SAVE popup.
2.
In the file list, select the S-4000 Input/Output Setup file
that you want to load.
3.
Press [F1 (LOAD)].
fig.S4M_LoadConf.eps
A confirmation message will ask you to confirm the
operation.
4.
When you press [F8 (LOAD)], a message indicating the
status of the load procedure will appear. When loading is
completed, the message will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Do not disconnect the USB memory or switch off the M-300’s
power while data is being saved to USB memory. Doing so
may destroy the data saved in USB memory.
Accessing the S-4000M LOAD/SAVE
popup
[F1 (LOAD)] Loads the S-4000M Input/Output Setup file
selected in the file list.
[F2 (SAVE)] Saves the S-4000M’s input/output setups.
[F3 (MAKE FOLDER)] Creates a folder in the file list.
[F4 (NAME EDIT)] Accesses the NAME EDIT popup where you can
edit the name of the file or folder.
[F5 (DELETE)] Deletes the selected file or folder from the file
list.
[F8 (CLOSE)] Closes the popup
1
1
Saving the S-4000M Input/Output Setup
file
Loading the S-4000M Input/Output
Setup file
M-300_e.book 147 ページ ２０１０年６月２４日 木曜日 午後２時２６分
To Next Page
Loading...
