Roland RSS M-300 - Clearing the Source Assignments; Setting the Source Assignments

179
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1. Access the M-48 SOURCE ASSIGN popup.
fig.ScrM48SrcAssign.eps
2.
In the assignment grid, move the cursor to the location
where the desired source and group intersect, and press
[ENTER] to make an assignment symbol appear.
A source can be assigned only to one group. You cannot assign
the same source to multiple groups.
1.
Access the M-48 SOURCE ASSIGN popup.
fig.ScrM48SrcAssign.eps
2.
Press [F7 (CLEAR ALL)].
fig.ScrM48SrcAssignClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (CLEAR)]; the source assignments will be
cleared and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Setting the source assignments
Clearing the source assignments
M-300_e.book 179 ページ ２０１０年６月２４日 木曜日 午後２時２６分