Roland RSS M-300 - Accessing the Effects Screen

99
Effects
Effects
● Dual mono
fig.ScrFxTypeMM.eps
This allows the effect to be used as two monaural effects.
These effects are used mainly for insertion in a channel.
● Singe mono
fig.ScrFXTypeSingleMono.eps
This is a singe monaural type effect. Only L side of the effect
is available.
OUT meters
These indicate the output level from the effect.
LR LINK button
This links the parameters of the effect between the L and R
sides.
The following effect types support LR LINK:
• DELAY x2
• P.SHIFTER x2
• CH STRIP x2
• SPH-323 x2
BYPASS L, R buttons
These buttons bypass the effect. When these are on, the
effect will be bypassed, and the input signal will be “thru-ed”
to the output. Separate buttons are provided for the L and R
channels.
You can also make the setting for switching bypass on or off
from a USER button (p. 136).
FX DESTINATION SELECT popup button
These select the output-destination for the effect. The
current output-destination is shown on the button. When
you move the cursor to the button and press [ENTER], the FX
DESTINATION SELECT popup will appear. This can be set
separately for the L and R channels.
If more than one output-destination channel are exist, the
lowest number channel is shown.
If you select insertion into a channel in the FX INSERT/SOURCE
SELECT popup, the corresponding FX DESTINATION SELECT
button will be unavailable. If you want to re-enable the FX
DESTINATION SELECT button, select an input-source other than
Insert in the corresponding FX INSERT/SOURCE SELECT popup.
The function buttons have the following operations:
1. In the EFFECTS section, press [INT FX].
fig.ScrFxRack.eps
The EFFECTS screen will appear.
[F1 (EDIT FX1)]–
[F4 (EDIT FX4)]
Accesses the FX EDIT popup (p. 102) for FX1–
FX4.
5
6
7
8
Accessing the EFFECTS screen
M-300_e.book 99 ページ ２０１０年６月２４日 木曜日 午後２時２６分