EasyManua.ls Logo

Roland RSS M-300 - Roland Vintage Effects

Roland RSS M-300
225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
214
Appendix
Appendix
Roland vintage effects
fig.ScrSBF325.eps
This is a stereo-in, stereo-out flanger that models the Roland SBF-
325 Stereo Flanger.
FEEDBACK
Amount of flanger sound returned to the input (valid only if
EFFECT MODE is set to FLANGER)
Value: 0.0–10.0
EFFECT MODE
Value
FLANGER I: Monaural mode flanger
FLANGER II: Stereo mode flanger
FLANGER III: Cross-mix mode flanger
OFF: Modulation off
CHORUS: Chorus
CH-B MOD (CH-B Modulation)
Specifies whether the channel B flanger effect will be inverted
Value: NORM, INV
CH-A
Specifies whether the channel A flanger sound will be phase-
reversed
Value: NORM, INV
CH-B
Specifies whether the channel B flanger sound will be phase-
reversed
Value: NORM, INV
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value: OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value: OFF, ON
LEVEL
Output level
Value: 0–100
fig.ScrSPH323.eps
This is a phase shifter that models the Roland SPH-323 Phase
Shifter. The original was mono-in, mono-out, but this modeling is
a dual-mono design with two units in parallel. The MOD LINK Sw
allows you to use this as a stereo-in, stereo-out effect.
CENTER FREQ (Center Frequency)
Center frequency at which the phaser effect is applied
Value: 0–100
RESONANCE
Boosts the region around the center frequency specified by
CENTER FREQ
Value: 0.0–10.0
SHIFT MODE
Specifies the number of stages for the phaser
Value: 8STAGE, 4STAGE
EFFECT Sw (Effect Switch)
Specifies whether the effect sound will be output
Value: OFF, ON
DIRECT Sw (Direct Switch)
Specifies whether the original sound will be output
Value: OFF, ON
LEVEL
Output level
Value: 0–100
MOD LINK Sw (Modulation Link Switch)
Specifies whether the modulation of the two SPH-323 units will
be linked
Value: OFF, ON
CH-B MOD (CH-B Modulation)
Specifies whether the phase of the modulation for channel B
(the lower SPH-323) will be inverted
Value: NORM, INV
SBF-325 (STEREO FLANGER SBF-325)
SPH-323 (PHASE SHIFTER SPH-323)
M-300_e.book 214 ページ 2010年6月24日 木曜日 午後2時26分

Table of Contents

Related product manuals