Roland RSS M-300 - Checking and Adjusting the Group MIX

181
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
LO GAIN knob
This adjusts the LO gain in a range of -15.0 dB – +15.0 dB.
The function buttons have the following operations:
1.
Access the desired M-48 GROUP MIX popup.
fig.ScrM48GrpMix1.eps
2.
Use [F1 (LAYER 1-8)] or [F2 (LAYER 9-16)] to choose the
group you want to view, and note the group mix settings.
Turning [F3 (EDIT EQ)] on will switch to the EQ setting
indication, allowing you to view the EQ values.
3.
If necessary, move the cursor to a parameter and use the
value dial to edit the value.
1.
Access the desired M-48 GROUP MIX popup.
fig.ScrM48GrpMix1.eps
2.
Press [F7 (RESET)].
fig.ScrM48GrpMixClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (RESET)]; the group mix will be reset to the
default settings.
Pressing [F7 (CANCEL)] will cancel the operation.
This operation will not change the group names.
The parameters of each group will be set to the following
values:
[F1 (LAYER 1-8)]
Switches the group layer.
[F2 (LAYER 9-16)]
[F3 (EDIT EQ)] Turning this on will switch to the EQ setting
display.
[F5 (REVERB ON)] Turns the reverb on/off.
[F6 (SOLO CLEAR)] Clears solo settings for all groups. This will be
on if any groups are soloed.
[F7 (RESET)] Returns the group mix to the default state (p.
181).
[F8 (CLOSE)] Closes the popup.
Checking and adjusting the group mix
11
Resetting the group mix to the default
settings
Parameter
Value
VOLUME
0.0 dB
PAN C
REVERB SEND -Inf dB
HI GAIN 0.0 dB
MID GAIN 0.0 dB
MID FREQ 1.00 kHz
LO GAIN 0.0 dB
SOLO OFF
M-300_e.book 181 ページ ２０１０年６月２４日 木曜日 午後２時２６分