Roland RSS M-300 - Checking and Adjusting the Musicians MIX (Group MIX)

180
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Checking and adjusting the musician’s mix (Group Mix)
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2. Press [F5 (GROUP MIX)].
fig.ScrM48GrpMix1_Guide.eps
The M-48 GROUP MIX popup will appear.
Target M-48 indication
This indicates the unit name of the M-48 that is the target of
the M-48 GROUP MIX popup.
Group mix
fig.ScrM48GrpMix1_Elm1_Gude.eps
Group number
This indicates the group number.
NAME
This indicates the group name.
You can move the cursor here and press [ENTER] to access the
NAME EDIT popup.
SOLO button
This turns solo on/off for each group.
EQ graph
This indicates the approximate response of the group’s EQ.
You can move the cursor here and press [ENTER] to turn the EQ
indication on/off.
REVERB SEND knob
This adjusts the group’s reverb send in a range of -Inf dB –
+10.0 dB.
PAN knob
This adjusts the group’s pan in a range of L63–C–R63.
This pan setting is a relative adjustment to the pan specified by
the source level/pan settings. In some cases, the M-48’s source
pan may reach the maximum or minimum value before this
value reaches the maximum or minimum value.
VOLUME knob
This volume setting is a relative adjustment to the level
specified by the source level/pan settings. In some cases, the M-
48’s source level may reach the maximum or minimum value
before this value reaches the maximum or minimum value.
The following knobs are shown if the EQ setting indication is
displayed:
fig.ScrM48GrpMix1_Elm2_Gude.eps
HI GAIN knob
This adjusts the HI gain in a range of -15.0 dB – +15.0 dB.
MID GAIN knob
This adjusts the MID gain in a range of -15.0 dB – +15.0 dB.
MID FREQ knob
This adjusts the MID center frequency in a range of 20 Hz–
20.0 kHz.
Accessing the M-48 GROUP MIX popup
2
1
1
2
2
3
4
5
6
1
7
1
2
3
4
5
6
7
8
9
10
11
8
9
10
M-300_e.book 180 ページ ２０１０年６月２４日 木曜日 午後２時２６分