175
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Source Level/Pan settings
This popup lets you set the source level and pan. Set the LEVEL,
PAN, and AUX switch for each source 1–40. Two views are
provided; the SOURCE LAYOUT tab and the M-300 LAYOUT tab.
• SOURCE LAYOUT tab
fig.ScrM48SrcLev1.eps
This shows the sources arranged in order of their number
(the order in the M-300’s REAC B output patchbay).
• M-300 LAYOUT tab
fig.ScrM48SrcLev2.eps
This shows the sources as they are seen from the M-300’s
fader module section. This display will change according to
the M-300’s channel layer.
Nothing is shown at the position of sources that are not patched
to the REAC B output.
If the same channel is being output multiple times to REAC B,
only the lowest-numbered output will be operable.
fig.ScrM48SrcLev_Guide.eps
Target M-48 indication
This shows the unit name of the M-48 that is the target of the
M-48 SOURCE LEV/PAN.
Source LEVEL/PAN
fig.ScrM48SrcLevEmnt_Guide.eps
Source number/name indication
In the SOURCE LAYOUT tab, this indicates the source number
and name.
In the M-300 LAYOUT tab, this indicates the M-300’s channel
number and name.
The M-300’s channel name or output name is used as the source
name.
In the SOURCE LAYOUT tab, the names of sources for which
nothing is being output from the M-300’s REAC B are not shown;
the background will be gray.
In the M-300 LAYOUT tab, channels not being output to the M-
300’s REAC B will have a gray background.
AUX button
If this is on, the post-fader signal will be mixed to the AUX
bus.
Meter
This indicates the input level of the source.
M-48 SOURCE LEV/PAN popup
The following outputs cannot be operated in the M-300
LAYOUT tab because they do not appear in the M-300’s top
panel fader module section:
• MAIN L, MAIN R, MAIN MONO
• MONITOR L, MONITOR R
• REC L, REC R
• TALKBACK/OSC
• REAC A IN1–40, REAC B IN1–40
• CONSOLE IN1–12
2
1
1
2
2
3
4
5
6
1
1
2
3
M-300_e.book 175 ページ ２０１０年６月２４日 木曜日 午後２時２６分
To Next Page
Loading...
