Roland RSS M-300 - Page 62

62
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
DELAY
fig.ScrChDelay.eps
DELAY button
This turns the delay on/off.
DELAY TIME
This indicates the delay time in milliseconds.
DELAY knob
This adjusts the amount of delay in a range of 0.0ms–
400.0ms (when delay unit is millisecond).
You can select one of the following delay units (p. 152):
The function buttons have the following operations:
If you press [F8 (Patchbay)] to access the PATCHBAY screen, the
currently selected channel will be highlighted in the PATCHBAY
screen.
The function button specific to the MAIN C has the following
operation:
The function buttons specific to the AUX have following
operations:
The function buttons specific to the MTX have following
operations:
ms
millisecond
ft Feet
m Meter
F Frame (24, 25, 29.97, 30fps)
[F2 (NAME EDIT)] Accesses the NAME EDIT popup where you can
specify the channel name (p. 50).
[F3 (COPY)] Accesses the AUX/MTX/MAIN COPY popup
where you can copy channel settings (p. 64).
[F4 (LIBRARY) Accesses the AUX/MTX/MAIN LIBRARY popup
where you can use the channel library (p. 65).
[F5 (GROUP ASSIGN)] Accesses the GROUP ASSIGN popup where you
can make DCA group and MUTE group
assignments (p. 53).
[F6 (PEAK CLEAR)] Clears the level meter peak hold or over
indication.
[F8 (Patchbay)] Accesses the PATCHBAY screen (p. 89).
11
1 2
3
1
2
3
[F1 (LINK to MAIN L/R)]
If you turn this on, you’ll be able to use the
MAIN fader to control MAIN L/R and MAIN C
while maintaining the fader balance between
MAIN L/R and MAIN C (p. 64).
[F1 (LINK)] Turns channel link on/off (p. 63).
[F7 (COPY MAIN MIX)] Copies the send amount from each input
channel to MAIN L/R. (p. 66)
[F1 (LINK)] Turns channel link on/off (p. 63).
[F7 (COPY MX MIX)] Copies the mix of a MTX to another MTX
channel (p. 67).
M-300_e.book 62 ページ ２０１０年６月２４日 木曜日 午後２時２６分