85
AUX send/MTX send
AUX send/MTX send
fig.PopAuxSendField2Guide.eps
Pan slider
This adjusts the left/right panning of the signal sent to the
stereo-linked AUX/MTX in a range of L63–R63.
PAN LINK button
This turns the PAN LINK switch on/off. If PAN LINK is on, the
pan from the channel to MAIN will be linked with the pan
from the channel to the stereo-linked AUX/MTX.
The function buttons have the following operations:
1.
Press the [SEL] button of any channel CH1–32 to select an
input channel.
2.
In the CHANNEL EDIT section’s AUX/MTX SENDS area,
press [DISP] to access the AUX/MTX SENDS popup.
3.
Press [F6 (ALL CH POINTS)] to access the ALL CH SEND
POINTS popup.
ig.ScrSendPoints_Guide.eps
Send point select buttons
These buttons select the send point for AUX1–8 or MTX1–4
from the following choices:
4.
Use the send point select buttons to select the desired
send point.
5.
Press [F8 (OK)]; the AUX/MTX send points you selected in
step 4 will be assigned for all channels CH1–32 in a single
operation, and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation and close
the popup.
[F1 (AUX 1-8)]
Displays the sends to AUX1–8.
[F2 (MTX 1-4)] Displays the sends to MTX1–4.
[F3 (ALL ON) Turns on all send switches for each send field.
[F4 (ALL OFF) Turns off all send switches for each send field.
[F5 (UNITY) Sets the send level to 0.0 dB for the send field at
the cursor location.
[F8 (CLOSE)] Closes the popup.
1
2
1
2
Setting all AUX/MTX send points in a
singe operations
Selection Explanation
Keep Maintains the current setting.
PRE EQ Specifies pre-EQ.
PRE FD Specifies pre-fader.
POST FD Specifies post-fader.
1
1
M-300_e.book 85 ページ ２０１０年６月２４日 木曜日 午後２時２６分
To Next Page
Loading...
