S-4000 Digital Snake Owner’s Manual 43
6—Using the S-4000 System
Recessed Rack-Mounting: S-4000H
Use the following procedure to remove and reinstall the S-4000H’s rack-mount brackets for recessed
rack-mounting.
1. Turn off the power on all equipment and disconnect all cables from the S-4000H unit.
2. Remove only the screws shown in the following diagram (6 screws on each side, 12 screws total),
and detach the rack-mount brackets from the sides of the unit as shown.
3. Using the screws you removed in Step 2, reinstall the rack-mount brackets as shown.
To Next Page
Loading...
