Roland S-4000S - S-4000 H Audio Connections; S-4000 H Audio Outputs; S-4000 H Audio Inputs

S-4000 Digital Snake Owner’s Manual 59
6—Using the S-4000 System
S-4000H Audio Connections
The S-4000H’s balanced audio I/O is provided in groups of eight on DB-25 connectors. See Appendix
B: Connector Information for DB-25 connector requirements and diagrams of the S-4000H’s INPUT and
OUTPUT connectors.










S-4000H Audio Outputs
The S-4000H’s audio outputs are used to receive audio signals connected to the S-4000S’s audio
inputs.
Connect the S-4000H’s balanced audio outputs to the destination device’s balanced line level (+4 dBu)
inputs.
In most cases, you’ll use a breakout cable—such as the RSS SC-A0805DM—for connecting the
S-4000H’s audio outputs to the balanced inputs on the receiving device. This cable has a DB-25
connector on one end and eight male XLR connectors on the other.
If the receiving audio device’s inputs are provided on DB-25 connectors, DB-25-to-DB-25 cables
with the appropriate wiring can be used. Refer to the documentation for the receiving device for
information on its DB-25 input wiring.
S-4000H Audio Inputs
The S-4000H’s audio inputs are used to send source audio signals to the S-4000S’s audio outputs.
Connect the sending device’s balanced line level (+4 dBu) outputs to the S-4000H’s balanced audio
inputs.
In most cases, you’ll use a breakout cable—such as the RSS SC-A0805DF—for connecting the sending
device’s balanced audio outputs to the S-4000H’s DB-25 audio input. This cable has a DB-25 connector
on one end and eight female XLR connectors on the other.