Roland S-4000S - Installing the Included Ferrite Cores on Ethernet Cables

S-4000 Digital Snake Owner’s Manual 47
6—Using the S-4000 System
Installing the Included Ferrite Cores on Ethernet Cables
Four ferrite cores are included with the S-4000 System for installation on Ethernet cables. Install a
ferrite core on the Ethernet cable near the RJ45 plug that will be connected to a REAC port.
Use the following procedure to install a ferrite core on an Ethernet cable.
1. Lift up the ferrite core’s tabs and open the ferrite core.
2. Place the Ethernet cable in the ferrite core so that the core abuts the base of the cable’s
connector.
3. Push the tabs until they close securely with a snapping sound.