Roland S-4000S - Advanced Use

S-4000 Digital Snake Owner’s Manual 71
Using Two S-4000R Units in a Single S-4000 System
As discussed in Chapter 6, the S-4000R can be connected to either the S-4000S or S-4000H. However,
if you have a second S-4000R (available separately), you can connect one to each unit. This allows for
control and signal monitoring of the S-4000 System at the location of either S-4000 unit.
The following behaviors occur when two S-4000Rs are used in a single system:
• Only one S-4000R unit can be used to edit S-4000S channels and recall/store memory presets at
any one time.
• When one S-4000R unit is in use, the other S-4000R unit automatically enters a locked state and
its LOCK button flashes.
See “Using the S-4000R Remote Controller” in Chapter 6 for information on operating the
S-4000R.
Advanced Use
7