Trigger Type rim and head settings are shared for all pads (PD-7/9, PD-120).
You cannot make settings for the internal pads. If you try to select the internal head by striking it,
“ ” is displayed.
4
Using PATCH/VALUE [+] or [-], set the Trigger Type.
If you don’t find the settings most suitable for your Trigger Type, then set the type you
think is closest.
Drum Pad: Pd7, P 1, P 2
Kick Pad: Kd7, K 1, K 2
Acoustic Drum Trigger: KiK, Snr, toM, FLr
For descriptions of each of the Trigger Types, see p. 45.
Up to this point, the procedure has been the same as in making normal Trigger Type set-
tings.
After setting the Trigger Type, the following operation is used to enter Advanced Edit
mode.
5
Confirm that Trigger Type (TRIG TYPE) in the SYSTEM parameter
group has been selected.
6
Hold down [EDIT] for several seconds. This takes you into
Advanced Edit mode.
fig. 58
In Advanced Edit mode, the SYSTEM Parameter Group indicator flashes.
One second after “Scn” appears in the display, the value is then displayed.
fig.59
This is the Scan Time settings screen.
If the TRIG TYPE settings screen does not come up, consequently, you can not call up the Advanced
Edit Mode screens by holding down [EDIT].
To Next Page
Loading...
Need help?
General
